The dash display will require:
A printer capable of printing up to 15.50” x 6” (393mm x 153mm).
A printer capable of printing in materials such as ABS,ABS-GF,ASA or PETG. The dash display is best printed in a heated chamber with PEI plate.
It is not recommended to print with PLA or any material that can deform to outside environment.You can print in any density down to 15” but it should have at least 4 walls for heat set inserts to grab into.
All printed pieces will require tree supports.
How I printed the dash display: I used a Anycubic Chiron with PEI Texture plate. I modified the chiron with a BIQU direct drive print head. I then built a plywood enclosure around the printer and use a cheap office heater to heat the enclosure. This printer is normally very slow so I used software to increase its speed with the direct drives faster ability. This improves the print time by 60% but the machine is very loud.
