Normally a Modder would only replace the rubber part of the clutch line with a braided line. This is because of lack of knowledge/experience and the existence of vendors offering a simple replacement.
However that is not the only solution. Â
This Guide demonstrates the ability to replace the entire OEM clutch line system with 1 hose and 2 fittings. This limits the locations of possible leaks and gives a clean install.
What you need:
- (1) 3AN stainless braided brake line no shorter than 32″ long with one 90deg end.
- (1) M10 to 3AN straight adapter
- (1) M10 to 3AN 90deg adapter
