Mazda Mx6
LS Turbo Project
This Mx6 originated from Texas and was shipped to Minnesota with a salvaged title in 2001. It was involved in a side swiped accident on the passenger side and suffered extensive damage to the front passenger fender, passenger door, rear 1/4 panel and windshield. After I had purchased it, I had promptly replaced these parts with either used or new. From then, it was about 3yrs before I had body work and paint done to it to make it look as it does today. Since ownership, the car has been a project is continued to today with performance in mind and modernization. It has been the canvas and inspiration for many of the parts offered on this website.
![](https://king6fab.com/wp-content/uploads/2024/04/ins-300x300.jpg)
Forged Engine Install
Removal Out with the old, in with the new. The motor I had in this car prior to the forged ...
![](https://king6fab.com/wp-content/uploads/2023/12/engine-300x300.jpg)
Forged KLDE Engine
Since 2007 I have been sitting on a used engine that I pulled from a rolled over 95 Mx6 V6 ...
![](https://king6fab.com/wp-content/uploads/2023/12/rad-300x300.jpg)
Radiator Upgrade
I decided to do a radiator upgrade to alleviate the requirement for a swirl pot, in addition to allowing more ...
![](https://king6fab.com/wp-content/uploads/2023/12/cool-300x300.jpg)
Intercooler Piping Upgrade
Lets start from the beginning. I chose 2in inter-cooler piping for easy routing, cost and I was told it could ...
![](https://king6fab.com/wp-content/uploads/2023/12/jspec1-300x300.jpg)
J-Spec Headlight Mounting
Mounting your J-Spec headlights on to a A-Spec chassis requires some cutting of the frame to make them fit. Provided ...
![](https://king6fab.com/wp-content/uploads/2023/12/jspec-300x300.jpg)
J-Spec Headlight Modification
This project involved removing the outer clear lens from each headlight in order to gain access to the projector housings. ...
![](https://king6fab.com/wp-content/uploads/2023/12/thu-300x300.jpg)
Tinted Tail Lights
This is a project that I have planned for a long time but couldn't quite figure out how to implement ...