Technical
Specs, Diagnostics & Diagrams for 2nd Gen Mx6, 626 and Ford Probe
![](https://king6fab.com/wp-content/uploads/2019/03/coilpacks-150x150.jpg)
Coil Packs Identification
Diyautotune IGN-6 Coil Pack This coil pack can only be found from Diyautotune.com, its expensive compared to other options and ...
![](https://king6fab.com/wp-content/uploads/2018/11/ebrake-150x150.jpg)
Rear Brake-Callipers – Design fault
Rear Brake-Callipers - Design fault on pre 5th Jan 95 versions, self-destruct Work-around - Short-lived, fix is rebuilt/new (Sumitomo redesigned) ...
![](https://king6fab.com/wp-content/uploads/2018/11/techdata-150x150.jpg)
Technical Data
Technical Data Ignition Area: Spark-plug gap: 1.0-1.1mm on 2.0 & 2.5 Spark plugs - 2.5: NGK ZFR5F-11 (standard), NGK ZFR6F-11 ...
![](https://king6fab.com/wp-content/uploads/2018/11/enginearc-150x150.jpg)
2nd generation Mazda MX6 & 626, Ford Probe Faq
Site Objective This website aims to provide a knowledge base for 2nd generation Mazda MX6 & 626, Ford Probe and ...
![](https://king6fab.com/wp-content/uploads/2018/08/ecufeatud-150x150.jpg)
KL Engine ECU Grounds
Bad grounds can result in no start issues and faulty sensor readings. Check ground connections for clean metal contact and ...
![](https://king6fab.com/wp-content/uploads/2018/08/obdtoobd2featud-150x150.jpg)
93-94 to 95+ Distributor Conversion
Information: Fact: The 1993-1994 (KL) V6 Engine ECU use 2 crank sensors, one crank sensor at the crank pulley, and ...
![](https://king6fab.com/wp-content/uploads/2018/08/partsfeatud-150x150.jpg)
Interchangeable parts
* 2nd Gen clutch line is same as 1st gen, interchangable * Clutch line is also interchangable with 1994 Ford ...
![](https://king6fab.com/wp-content/uploads/2018/08/specsfeatured-150x150.jpg)
1993-1997 2nd Gen Torque Specs
SEAT BELTS All seat belt anchors = 29-57 ft. lbs. Seat belt retractors = 29-57 ft. lbs. STARTER 28-38 ft ...
![](https://king6fab.com/wp-content/uploads/2018/08/bulbsfeaturd-150x150.jpg)
1993-1997 MAZDA MX-6 Bulb Numbers
Angel Eye Halo High & Low Beam H7 ASPECS High & Low Beam 9004 JSPECS High Beam H3C JSPECS Low ...
![](https://king6fab.com/wp-content/uploads/2018/08/diagnfeatud-150x150.jpg)
93-94 Ignition Diagnosis
Step 1. Testing for Power (Figure 1) Here we are testing for 12 volt power to the distributor. This is ...
![](https://king6fab.com/wp-content/uploads/2018/08/obd1featued-150x150.jpg)
1993-1995 OBD1 KLDE V6 CEL Codes
1993-1995 v6 KLDE CEL Codes The OBD-1 computer system was used in the 93-95 Ford Probe, Mx6 & 626 To ...
![](https://king6fab.com/wp-content/uploads/2018/08/obd2celfeaturd-150x150.jpg)
1996-1997 OBD2 KLDE V6 CEL Codes
OBD-2 codes for the 1996+ KLDE V6 MX6, 626 and Ford Probe These codes must be read from the car ...