![](https://king6fab.com/wp-content/uploads/2024/04/list2-2.png)
00. King6 Mx6 Build List
Engine Management & Ignition Megasquirt Plug and Play G2 $800.00 Quad Spark $90.00 Ign-6 Coil Pack $70.00 Wiring and Delpi ...
![](https://king6fab.com/wp-content/uploads/2024/04/sparkplugicon-1.png)
02. MSPNP Ignition Options
Now that your replacing the ECU with a PNP unit, you have options for ignition control, The MSPNP will run ...
![](https://king6fab.com/wp-content/uploads/2024/04/injectoricon-1.png)
03. Fuel Managment
Upgrade the Fuel Pump At the very minimum, a 255lph fuel pump is required, Walbro makes a nice unit that ...
![](https://king6fab.com/wp-content/uploads/2024/04/batteryicon-1.png)
04. Battery Relocation
Mounting and Wiring Typically the battery is mounted in the rearrest of the trunk, but it could be mounted anywhere ...
![](https://king6fab.com/wp-content/uploads/2024/04/engineicon-1.png)
05. Engine Preparation
Disabling VRIS Now that you will be boosting in the range that the VRIS normally operates, you will no longer ...
![](https://king6fab.com/wp-content/uploads/2024/04/turboicon-1.png)
06. Turbo Setup
Turbo Hot Pipes - There are a few brands out on the market, but they are basically the same. These ...
![](https://king6fab.com/wp-content/uploads/2024/04/fanicon-1.png)
07. Cooling
The stock radiator and fan system is sufficient enough for turbo charging the engine, however now with the addition of ...
![](https://king6fab.com/wp-content/uploads/2024/04/intercooler-1.png)
08. Intercooler Piping
Next, you will need to decide your method of cooling the air charge, its not absolutely necessary, but is essential ...
![](https://king6fab.com/wp-content/uploads/2024/04/rp-1.png)
09. MSPNP Boost Setup
Step 1. Setting up your Megasquirt settings If you haven’t already bought the full version of Tunerstudio, I highly recommend ...