{"id":45,"date":"2024-10-27T01:42:50","date_gmt":"2024-10-27T01:42:50","guid":{"rendered":"https:\/\/king6fab.com\/info\/?p=45"},"modified":"2024-10-27T03:05:08","modified_gmt":"2024-10-27T03:05:08","slug":"visual-composer-45","status":"publish","type":"post","link":"https:\/\/king6fab.com\/info\/archives\/45","title":{"rendered":"02. IAT Sensor"},"content":{"rendered":"
<\/div>

Intake Air Tempature Sensor<\/h3>
<\/div><\/div><\/div>

This will allow you to remove the stock VAF from the intake system.<\/span><\/p>

 <\/p>

 <\/p>

 <\/p><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div><\/div>

Intake Air Temp Sensor <\/strong>(IAT)<\/span><\/p>

All that you will need For the MSPNP is a GM Open Elemant IAT Sensor, This simple sensor will allow you eliminate the oem VAF from your intake piping.<\/span><\/p>

These sensors can be found almost at any local parts store.  Try to find a sensor with a premade pigtail and a 3\/8 NPT weld on bung in the metal type your using for inter-cooler piping. Diyautotune.com sells the exact sensor with pigtail that  and bung you will need.<\/a><\/span><\/p>

This sensor will need to be personally wired to your MSPNP Options port . One wire of the IAT pigtail will need to be grounded, the other wire will go to IAT sensor input<\/b> on your MSPNP options port.  Recommended wire size is 16-18GA, run both wires to the MSPNP, use any ground location near the ECU.<\/span><\/p><\/div><\/div><\/div><\/div><\/div>

\"\"<\/div><\/div>